Agilent Technologies 33250A User Manual page 264

-222
-222
-222
-222
5
-222
-222
Chapter 5 Error Messages
Execution Errors
Data out of range;
marker confined to sweep span; value clipped to ...
This generic message indicates that the specified marker frequency is
outside the range of the start frequency and stop frequency. The marker
frequency must be between the specified start frequency and stop
frequency. If you attempt to set the marker frequency to a frequency
not in this range, the function generator will automatically set the
marker frequency equal to the start frequency or stop frequency
(whichever is closer). This error is generated only when both the sweep
mode and the marker frequency are enabled.
Data out of range;
pulse width; value clipped to ...
This generic message indicates that the desired pulse width is limited to
an upper or lower boundary which is usually dictated by the period of the
pulse waveform.
Data out of range;
pulse edge time; value clipped to ...
This generic message indicates that the desired edge time is limited to
an upper or lower boundary which is usually dictated by the pulse width
and/or period of the pulse waveform.
Data out of range;
FM deviation; value clipped to ...
This generic message indicates that the desired FM deviation is limited
to a lower or upper boundary as set by the current function's frequency.
Data out of range;
trigger delay; value clipped to upper limit
The trigger delay is limited to a maximum of 85 seconds. The trigger
delay sets the time between the receipt of the trigger and the start of the
burst waveform (used in triggered burst mode only).
Data out of range;
trigger delay limited by length of burst; value clipped to upper limit
The sum of the specified trigger delay and the time required to complete
the burst waveform must be less than the period of the burst.
264