To Store The Instrument State - Agilent Technologies 33250A User Manual

To Store the Instrument State

You can store the instrument state in one of four non-volatile storage
locations. A fifth storage location automatically holds the power-down
configuration of the instrument. When power is restored, the instrument
can automatically return to its state before power-down.
1 Select the desired storage location.
Press and then select the Store State softkey.
2 Select a custom name for the selected location.
If desired, you can assign a custom name to each of the four locations.
• The name can contain up to 12 characters. The first character must
be a letter but the remaining characters can be letters, numbers, or
the underscore character ("_").
• To add additional characters, press the right-arrow key until the
cursor is to the right of the existing name and then turn the knob.
• To delete all characters to the right of the cursor position, press
• To use numbers in the name, you can enter them directly from the
numeric keypad. Use the decimal point from the numeric keypad to
add the underscore character ("_") to the name.
3 Store the instrument state.
Press the STORE STATE softkey. The instrument stores the selected
function, frequency, amplitude, dc offset, duty cycle, symmetry, as well
as any modulation parameters in use. The instrument does not store
volatile waveforms created in the arbitrary waveform function.
Chapter 2 Front-Panel Menu Operation
To Store the Instrument State
2
4
.
43