To Set The Duty Cycle - Agilent Technologies 33250A User Manual

To Set the Duty Cycle

Applies only to square waves. At power-on, the duty cycle for square
waves is 50%. You can adjust the duty cycle from 20% to 80% for output
frequencies up to 25 MHz. The following steps show you how to change
the duty cycle to 30%.
1 Select the square wave function.
Press the key and then set the desired output frequency to any
value less than 25 MHz.
2 Press the "Duty Cycle" softkey.
The displayed duty cycle is either the power-on value or the percentage
previously selected. The duty cycle represents the amount of time per
cycle that the square wave is at a high level (note the icon on the right
side of the display).
3 Enter the desired duty cycle.
Using the numeric keypad or the knob, select a duty cycle value of "30".
The function generator adjusts the duty cycle immediately and outputs a
square wave with the specified value (if the output is enabled).
Chapter 1 Quick Start
To Set the Duty Cycle
4
21
1