Burst Commands - Agilent Technologies 33250A User Manual

4
Chapter 4 Remote Interface Reference
SCPI Command Summary

Burst Commands

(see page 187 for more information)
BURSt:MODE {TRIGgered|GATed}
BURSt:MODE?
# cycles
BURSt:NCYCles {<
BURSt:NCYCles? [MINimum|MAXimum]
BURSt:INTernal:PERiod {<
BURSt:INTernal:PERiod? [MINimum|MAXimum]
angle
BURSt:PHASe {<
BURSt:PHASe? [MINimum|MAXimum]
BURSt:STATe {OFF|ON}
BURSt:STATe?
UNIT:ANGLe {DEGree|RADian}
UNIT:ANGLe?
TRIGger:SOURce {IMMediate|EXTernal|BUS} Triggered Burst
TRIGger:SOURce?
seconds
TRIGger:DELay {<
TRIGger:DELay? [MINimum|MAXimum]
TRIGger:SLOPe {POSitive|NEGative}
TRIGger:SLOPe?
BURSt:GATE:POLarity {NORMal|INVerted}
BURSt:GATE:POLarity?
OUTPut
:TRIGger:SLOPe {POSitive|NEGative}
:TRIGger:SLOPe?
:TRIGger {OFF|ON}
:TRIGger?
Parameters shown in bold are selected following a *RST (reset) command.
136
>|INFinity|MINimum|MAXimum}
seconds
>|MINimum|MAXimum}
>|MINimum|MAXimum}
>|MINimum|MAXimum}
"Trig In" Connector
External Gated Burst
"Trig Out" Connector