Using The Operation Panel (Advanced Operations); Switching The 4-Column Display; Setting The Sewing Speed; Setting The Maximum Sewing Speed - Brother S-7000DD Instruction Manual

4. USING THE OPERATION PANEL
(ADVANCED OPERATIONS)
The operations described in this section should only be carried out by a technician.

4-1. Switching the 4-column display

・ The 4-column data in the display can be changed to one of the following three statuses each time the SEL key is pressed.
Stitch number display or no display  Sewing speed display  Counter display
・ When the sewing speed display/counter display appears, you can press the FUNC key to switch to another display.
Display mode
No display
Stitch number
display
Sewing speed
display
Counter display

4-2. Setting the sewing speed

4-2-1. Setting the maximum sewing speed

1
Press the SEL key so that the SPEED indicator is illuminated.
2
Press the A or B
ON
ON
ON
Flashing
ON ON
ON
Flashing
key to change the setting value.

4. USING THE OPERATION PANEL (ADVANCED OPERATIONS)

ON ABCD stitch number display
Maximum sewing speed setting value
ON Start backtack sewing speed setting value
Lower thread counter value
Lower thread counter warning enabled
Thread trimming counter value
ON Needle replacement counter value
Flashing Needle replacement counter warning enabled
・ The maximum sewing speed setting value
will appear in the four columns of the
display.
・ When the B
increases by 100.
・ When the A
decreases by 100.
NOTE:
The setting range is from 220 to 4000
sti/min.
S-7000DD
Four columns display
0502D 0503D 0504D
key is pressed, the setting
key is pressed, the setting
0505D
0506D
16