Cam Optimization; Troubleshoot Cam Profiling; Cam Profile Mismatches; Qos Cam Region Limitation - Dell S4820T Configuration Manual

|
|
7 | 0
|
|
|
|
|
Codes: * - cam usage is above 90%.
Dell#

CAM Optimization

When you enable the CAM optimization, if a Policy Map containing classification rules (ACL and/or DSCP/
ip-precedence rules) is applied to more than one physical interface on the same port-pipe, only a single
copy of the policy is written (only one FP entry is used).

Troubleshoot CAM Profiling

The following section describes CAM profiling troubleshooting.

CAM Profile Mismatches

The CAM profile on all cards must match the system profile. In most cases, the system corrects
mismatches by copying the correct profile to the card, and rebooting the card. If three resets do not
bring up the card, or if the system is running an Dell Networking OS version prior to version 6.3.1.1, the
system displays an error message. In this case, manually adjust the CAM configuration on the card to
match the system configuration.
To prevent mismatches, Dell Networking recommends the following:
• Use the eg-default CAM profile in a chassis that has only EG Series line cards. If this profile is used in a
chassis with non-EG line cards, the non-EG line cards enter a problem state.
• Before moving a card to a new chassis, change the CAM profile on a card to match the new system
profile.
• After installing a secondary RPM into a chassis, copy the running-configuration to the startup-
configuration.
• Change to the default profile if downgrading to a Dell Networking OS version earlier than 6.3.1.1.
• Use the CONFIGURATION mode commands so that the profile is change throughout the system.
• Use the EXEC Privilege mode commands to match the profile of a component to the profile of the
target system.

QoS CAM Region Limitation

To store QoS service policies, the default CAM profile allocates a partition within the IPv4Flow region.
If the QoS CAM space is exceeded, a message similar to the following displays.
%EX2YD:12 %DIFFSERV-2-DSA_QOS_CAM_INSTALL_FAILED: Not enough space in L3
Cam(PolicyQos) for class 2 (Te 1/20) entries on portpipe 1 for linecard 1
%EX2YD:12 %DIFFSERV-2-
DSA_QOS_CAM_INSTALL_FAILED: Not enough space in L3 Cam(PolicyQos) for
Content Addressable Memory (CAM)
| OUT-V6 ACL |
| OUT-L2 ACL |
| IN-L3 ACL |
| IN-V6 ACL |
| IN-L2 ACL |
| OUT-L3 ACL |
| OUT-V6 ACL |
| OUT-L2 ACL |
158 | 0
206 | 7
512 | 1
0 |
768 |
158 |
158 |
206 |
| 158
| 199
| 511
0 | 0
0 | 768
5 | 153
0 | 158
7 | 199
269