Counting Acl Hits; Configure Ingress Acls - Dell S4820T Configuration Manual

Counting ACL Hits

You can view the number of packets matching the ACL by using the count option when creating ACL
entries.
1. Create an ACL that uses rules with the count option. Refer to
2. Apply the ACL as an inbound or outbound ACL on an interface.
3.
show ip accounting access-list
EXEC Privilege mode
View the number of packets matching the ACL.

Configure Ingress ACLs

Ingress ACLs are applied to interfaces and to traffic entering the system.
These system-wide ACLs eliminate the need to apply ACLs onto each interface and achieves the same
results. By localizing target traffic, it is a simpler implementation.
To create an ingress ACL, use the ip access-group command in EXEC Privilege mode. The example
shows applying the ACL, rules to the newly created access group, and viewing the access list.
Example of Applying ACL Rules to Ingress Traffic and Viewing ACL Configuration
To specify ingress, use the in keyword. Begin applying rules to the ACL with the ip access-list
extended abcd command. To view the access-list, use the show command.
Dell(conf)#interface tengigabitethernet 1/1
Dell(conf-if-te1/1)#ip access-group abcd in
Dell(conf-if-te1/1)#show config
!
tengigabitethernet 1/1
no ip address
ip access-group abcd in
no shutdown
Dell(conf-if-te1/1)#end
Dell#configure terminal
Dell(conf)#ip access-list extended abcd
Dell(config-ext-nacl)#permit tcp any any
Dell(config-ext-nacl)#deny icmp any any
Dell(config-ext-nacl)#permit 1.1.1.2
Dell(config-ext-nacl)#end
Dell#show ip accounting access-list
!
Extended Ingress IP access list abcd on tengigabitethernet 1/1
seq 5 permit tcp any any
seq 10 deny icmp any any
seq 15 permit 1.1.1.2
Dell(conf)#interface tengigabitethernet 1/1/1
Dell(conf-if-te1/1/1)#ip access-group abcd in
Dell(conf-if-te1/1/1)#show config
!
tengogabitethernet 1/1/1
no ip address
Access Control Lists (ACLs)
Configure a Standard IP ACL Filter.
143