Configuring A Static Route; Sample Vrf Configuration - Dell S4820T Configuration Manual

• ipv6 nd prefix — Configure IPv6 Routing Prefix Advertisement
• ipv6 nd ra-guard — Configure IPv6 ra-guard
• ipv6 nd ra-lifetime — Set IPv6 Router Advertisement Lifetime
• ipv6 nd reachable-time — Set advertised reachability time
• ipv6 nd retrans-timer — Set NS retransmit interval used and advertised in RA
• ipv6 nd suppress-ra — Suppress IPv6 Router Advertisements
• ipv6 ad <ipv6-address> — IPv6 Address Detection
• ipv6 ad autoconfig — IPv6 stateless auto-configuration
• ipv6 address <ipv6-address> — Configure IPv6 address on an interface
NOTE: The command line help still displays relevant details corresponding to each of these
commands. However, these interface range or interface group commands are not supported when
Management VRF is configured.

Configuring a Static Route

To configure a static route, perform the following steps:
Task
Configure a static route that
points to a management
interface.
To configure a static entry in the IPv6 neighbor discovery, perform the following steps:
Task
Configure a static neighbor.

Sample VRF Configuration

The following configuration illustrates a typical VRF set-up.
1102
Command Syntax
management route ip-
address mask
managementethernet
ormanagement route ipv6-
address prefix-length
managementethernet
NOTE: You can also have
the management route to
point to a front-end port in
case of the management
VRF. For example:
management route 2::/64 te
0/0.
Command Syntax
ipv6 neighbor vrf
management 1::1
tengigabitethernet 1/1
xx:xx:xx:xx:xx:xx
Command Mode
CONFIGURATION
Command Mode
CONFIGURATION
Virtual Routing and Forwarding (VRF)