Vrrp For Ipv6 Configuration - Dell S4820T Configuration Manual

This time is the gap between an interface coming up and being operational, and VRRP enabling.
The seconds range is from 0 to 900.
The default is 0.
• Set the delay time for VRRP initialization on all the interfaces in the system configured for VRRP.
INTERFACE mode
vrrp delay reload seconds
This time is the gap between system boot up completion and VRRP enabling.
The seconds range is from 0 to 900.
The default is 0.

VRRP for IPv6 Configuration

This section shows VRRP IPv6 topology with CLI configurations.
Consider an example VRRP for IPv6 configuration in which the IPv6 VRRP group consists of two routers.
NOTE: This example does not contain comprehensive directions and is intended to provide
guidance for only a typical VRRP configuration. You can copy and paste from the example to your
CLI. Be sure you make the necessary changes to support your own IP addresses, interfaces, names,
and so on.
Virtual Router Redundancy Protocol (VRRP)
1129