Rip Configuration Example - Dell S4820T Configuration Manual

Dell#debug ip rip
RIP protocol debug is ON
Dell#
To disable RIP, use the no debug ip rip command.

RIP Configuration Example

The examples in this section show the command sequence to configure RIPv2 on the two routers shown
in the following illustration — Core 2 and Core 3.
The host prompts used in the following example reflect those names. The examples are divided into the
following groups of command sequences:
• Configuring RIPv2 on Core 2
• Core 2 RIP Output
• RIP Configuration on Core 3
• Core 3 RIP Output
• RIP Configuration Summary
Figure 108. RIP Topology Example
RIP Configuration on Core2
The following example shows how to configure RIPv2 on a host named Core2.
Example of Configuring RIPv2 on Core 2
Core2(conf-if-te-2/3)#
Core2(conf-if-te-2/3)#router rip
Core2(conf-router_rip)#ver 2
Core2(conf-router_rip)#network 10.200.10.0
Core2(conf-router_rip)#network 10.300.10.0
Core2(conf-router_rip)#network 10.11.10.0
Core2(conf-router_rip)#network 10.11.20.0
Core2(conf-router_rip)#show config
!
router rip
network 10.0.0.0
version 2
Core2(conf-router_rip)#
Routing Information Protocol (RIP)
833