Resequencing An Acl Or Prefix List - Dell S4820T Configuration Manual

You can resequence IPv4 and IPv6 ACLs, prefixes, and MAC ACLs. No CAM writes happen as a result of
resequencing, so there is no packet loss; the behavior is similar Hot-lock ACLs.
NOTE: ACL resequencing does not affect the rules, remarks, or order in which they are applied.
Resequencing merely renumbers the rules so that you can place new rules within the list as needed.
Table 9. ACL Resequencing
Rules
Rules Before Resequencing:
Rules After Resequencing:

Resequencing an ACL or Prefix List

Resequencing is available for IPv4 and IPv6 ACLs, prefix lists, and MAC ACLs.
To resequence an ACL or prefix list, use the following commands. You must specify the list name, starting
number, and increment when using these commands.
• IPv4, IPv6, or MAC ACL
EXEC mode
resequence access-list {ipv4 | ipv6 | mac} {access-list-name StartingSeqNum
Step-to-Increment}
• IPv4 or IPv6 prefix-list
EXEC mode
resequence prefix-list {ipv4 | ipv6} {prefix-list-name StartingSeqNum Step-
to-Increment}
Examples of Resequencing ACLs When Remarks and Rules Have the Same Number or have Different
Numbers
Remarks and rules that originally have the same sequence number have the same sequence number after
you apply the resequence command.
The example shows the resequencing of an IPv4 access-list beginning with the number 2 and
incrementing by 2.
Dell(config-ext-nacl)# show config
!
ip access-list extended test
remark 4 XYZ
remark 5 this remark corresponds to permit any host 1.1.1.1
seq 5 permit ip any host 1.1.1.1
Access Control Lists (ACLs)
Resquencing
seq 5 permit any host 1.1.1.1
seq 6 permit any host 1.1.1.2
seq 7 permit any host 1.1.1.3
seq 10 permit any host 1.1.1.4
seq 5 permit any host 1.1.1.1
seq 10 permit any host 1.1.1.2
seq 15 permit any host 1.1.1.3
seq 20 permit any host 1.1.1.4
151