Interface Types; View Basic Interface Information - Dell S4820T Configuration Manual

Interface Types

The following table describes different interface types.
Interface Type Modes Possible
Physical L2, L3
Management N/A
Loopback L3
Null N/A
Port Channel L2, L3
VLAN L2, L3
Fibre Channel TF, F, E-
Interface Port

View Basic Interface Information

To view basic interface information, use the following command.
You have several options for viewing interface status and configuration parameters.
• Lists all configurable interfaces on the chassis.
EXEC mode
show interfaces
This command has options to display the interface status, IP and MAC addresses, and multiple
counters for the amount and type of traffic passing through the interface.
If you configured a port channel interface, this command lists the interfaces configured in the port
channel.
NOTE: To end output from the system, such as the output from the show interfaces
command, enter CTRL+C and Dell Networking OS returns to the command prompt.
430
Default Mode Requires Creation
Unset No
N/A No
L3 Yes
N/A No
L3 Yes
Yes (except default) L2 - Shutdown
L2
TF- No
port
Default State
Shutdown
(disabled)
No Shutdown
(enabled)
No Shutdown
(enabled)
Enabled
Shutdown
(disabled)
(disabled)
L3 - No Shutdown
(enabled)
Shutdown
Interfaces