Aaa Authorization; Privilege Levels Overview - Dell S4820T Configuration Manual

verify that you have successfully obscured passwords and keys, use the show running-config
command or show startup-config command.
If you are using role-based access control (RBAC), only the system administrator and security
administrator roles can enable the service obscure-password command.
To enable the obscuring of passwords and keys, use the following command.
• Turn on the obscuring of passwords and keys in the configuration.
CONFIGURATION mode
service obscure-passwords
Example of Obscuring Password and Keys
Dell(config)# service obscure-passwords

AAA Authorization

Dell Networking OS enables AAA new-model by default.
You can set authorization to be either local or remote. Different combinations of authentication and
authorization yield different results. By default, Dell Networking OS sets both to local.

Privilege Levels Overview

Limiting access to the system is one method of protecting the system and your network. However, at
times, you might need to allow others access to the router and you can limit that access to a subset of
commands. In Dell Networking OS, you can configure a privilege level for users who need limited access
to the system.
Every command in Dell Networking OS is assigned a privilege level of 0, 1, or 15. You can configure up to
16 privilege levels in Dell Networking OS. Dell Networking OS is pre-configured with three privilege levels
and you can configure 13 more. The three pre-configured levels are:
• Privilege level 1 — is the default level for EXEC mode. At this level, you can interact with the router,
for example, view some show commands and Telnet and ping to test connectivity, but you cannot
configure the router. This level is often called the "user" level. One of the commands available in
Privilege level 1 is the enable command, which you can use to enter a specific privilege level.
• Privilege level 0 — contains only the end, enable, and disable commands.
• Privilege level 15 — the default level for the enable command, is the highest level. In this level you
can access any command in Dell Networking OS.
Privilege levels 2 through 14 are not configured and you can customize them for different users and
access.
After you configure other privilege levels, enter those levels by adding the level parameter after the
enable command or by configuring a user name or password that corresponds to the privilege level. For
more information about configuring user names, refer to
By default, commands in Dell Networking OS are assigned to different privilege levels. You can access
those commands only if you have access to that privilege level. For example, to reach the protocol
Security
Configuring a Username and Password.
861