Dell S4820T Configuration Manual page 322

Field
Admin mode
Admin Parameters
Remote Parameters
Local Parameters
Operational status (local port)
ETS DCBx Oper status
State Machine Type
Conf TLV Tx Status
ETS TLV Statistic: Input Conf TLV pkts
ETS TLV Statistic: Output Conf TLV pkts
ETS TLV Statistic: Error Conf TLV pkts
The following example shows the show stack-unit all stack-ports all pfc details
command.
Dell(conf)# show stack-unit all stack-ports all pfc details
stack unit 0 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
322
Description
ETS mode: on or off.
ETS configuration on local port, including priority
groups, assigned dot1p priorities, and bandwidth
allocation.
ETS configuration on remote peer port, including
Admin mode (enabled if a valid TLV was received
or disabled), priority groups, assigned dot1p
priorities, and bandwidth allocation. If the ETS
Admin mode is enabled on the remote port for
DCBx exchange, the Willing bit received in ETS
TLVs from the remote peer is included.
ETS configuration on local port, including Admin
mode (enabled when a valid TLV is received from a
peer), priority groups, assigned dot1p priorities, and
bandwidth allocation.
Port state for current operational ETS
configuration:
• Init: Local ETS configuration parameters were
exchanged with peer.
• Recommend: Remote ETS configuration
parameters were received from peer.
• Internally propagated: ETS configuration
parameters were received from configuration
source.
Operational status of ETS configuration on local
port: match or mismatch.
Type of state machine used for DCBx exchanges of
ETS parameters:
• Feature: for legacy DCBx versions
• Asymmetric: for an IEEE version
Status of ETS Configuration TLV advertisements:
enabled or disabled.
Number of ETS Configuration TLVs received.
Number of ETS Configuration TLVs transmitted.
Number of ETS Error Configuration TLVs received.
Data Center Bridging (DCB)