Dell S4820T Configuration Manual page 724

• Enable IPsec encryption for OSPFv3 packets in an area.
CONF-IPV6-ROUTER-OSPF mode
area area-id encryption ipsec spi number esp encryption-algorithm [key-
encryption-type] key authentication-algorithm [key-authentication-type] key
– area area-id: specifies the area for which OSPFv3 traffic is to be encrypted. For area-id, enter
a number or an IPv6 prefix.
– spi number: is the security policy index (SPI) value. The range is from 256 to 4294967295.
– esp encryption-algorithm: specifies the encryption algorithm used with ESP. The valid values
are 3DES, DES, AES-CBC, and NULL. For AES-CBC, only the AES-128 and AES-192 ciphers are
supported.
– key: specifies the text string used in the encryption. All neighboring OSPFv3 routers must share
the same key to decrypt information. The required lengths of a non-encrypted or encrypted key
are: 3DES - 48 or 96 hex digits; DES - 16 or 32 hex digits; AES-CBC - 32 or 64 hex digits for
AES-128 and 48 or 96 hex digits for AES-192.
– key-encryption-type: (optional) specifies if the key is encrypted. Valid values: 0 (key is not
encrypted) or 7 (key is encrypted).
– authentication-algorithm: specifies the authentication algorithm to use for encryption. The
valid values are MD5 or SHA1.
– key: specifies the text string used in authentication. All neighboring OSPFv3 routers must share
key to exchange information. For MD5 authentication, the key must be 32 hex digits (non-
encrypted) or 64 hex digits (encrypted). For SHA-1 authentication, the key must be 40 hex digits
(non-encrypted) or 80 hex digits (encrypted).
– key-authentication-type: (optional) specifies if the authentication key is encrypted. The valid
values are 0 or 7.
• Remove an IPsec encryption policy from an OSPFv3 area.
no area area-id encryption ipsec spi number
• Display the configuration of IPsec encryption policies on the router.
show crypto ipsec policy
Displaying OSPFv3 IPsec Security Policies
To display the configuration of IPsec authentication and encryption policies, use the following
commands.
• Display the AH and ESP parameters configured in IPsec security policies, including the SPI number,
key, and algorithms used.
EXEC Privilege mode
show crypto ipsec policy [name name]
– name: displays configuration details about a specified policy.
• Display security associations set up for OSPFv3 links in IPsec authentication and encryption policies
on the router.
EXEC Privilege
show crypto ipsec sa ipv6 [interface interface]
To display information on the SAs used on a specific interface, enter interface interface, where
interface is one of the following values:
724
Open Shortest Path First (OSPFv2 and OSPFv3)