Influencing Mstp Root Selection - Dell S4820T Configuration Manual

Designated port id is 128.374, designated path cost 20000
Number of transitions to forwarding state 1
BPDU (MRecords): sent 93671, received 46843
The port is not in the Edge port mode
Port 384 (TenGigabitEthernet 1/31) is alternate Discarding
Port path cost 20000, Port priority 128, Port Identifier 128.384
Designated root has priority 32768, address 0001.e806.953e
Designated bridge has priority 32768, address 0001.e809.c24a
Designated port id is 128.384, designated path cost 20000
Number of transitions to forwarding state 1
BPDU (MRecords): sent 39291, received 7547
The port is not in the Edge port mode

Influencing MSTP Root Selection

MSTP determines the root bridge, but you can assign one bridge a lower priority to increase the
probability that it becomes the root bridge.
To change the bridge priority, use the following command.
• Assign a number as the bridge priority.
PROTOCOL MSTP mode
msti instance bridge-priority priority
A lower number increases the probability that the bridge becomes the root bridge.
The range is from 0 to 61440, in increments of 4096.
The default is 32768.
Example of Assigning and Verifying the Root Bridge Priority
By default, the simple configuration shown previously yields the same forwarding path for both MSTIs.
The following example shows how R3 is assigned bridge priority 0 for MSTI 2, which elects a different
root bridge than MSTI 2.
To view the bridge priority, use the show config command from PROTOCOL MSTP mode.
R3(conf-mstp)#msti 2 bridge-priority 0
1d2h51m: %RPM0-P:RP2 %SPANMGR-5-STP_ROOT_CHANGE: MSTP root changed for instance
2. My
Bridge ID: 0:0001.e809.c24a Old Root: 32768:0001.e806.953e New Root:
0:0001.e809.c24a
R3(conf-mstp)#show config
!
protocol spanning-tree mstp
no disable
MSTI 1 VLAN 100
MSTI 2 VLAN 200,300
MSTI 2 bridge-priority 0
650
Multiple Spanning Tree Protocol (MSTP)