Configuring Fp Blocks For Vlan Parameters - Dell S4820T Configuration Manual

SpecialAccessOnlyExpertsAllowed
Vlan Members :
100,200,300
Group Name :
CustomerNumberIdentificationEleven
Egress IP Acl :
AnyEmployeeCustomerElevenGrantedAccess
Vlan Members :
2-10,99
Group Name :
HostGroup
Egress IP Acl :
Group5
Vlan Members :
1,1000
Dell#

Configuring FP Blocks for VLAN Parameters

To allocate the number of FP blocks for the various VLAN processes on the system, use the cam-acl-
vlan command. To reset the number of FP blocks to the default, use the no version of this command. By
default, 0 groups are allocated for the ACL in VLAN contentaware processor (VCAP). ACL VLAN groups or
CAM optimization is not enabled by default. You also must allocate the slices for CAM optimization.
1. Allocate the number of FP blocks for VLAN operations.
CONFIGURATION mode
cam-acl-vlan vlanopenflow <0-2>
2. Allocate the number of FP blocks for VLAN iSCSI counters.
CONFIGURATION mode
cam-acl-vlan vlaniscsi <0-2>
3. Allocate the number of FP blocks for ACL VLAN optimization.
CONFIGURATION mode
cam-acl-vlan vlanaclopt <0-2>
4. View the number of FP blocks that is allocated for the different VLAN services.
EXEC Privilege mode
Dell#show cam-usage switch
Stackunit|Portpipe| CAM Partition
========|========|=================|============|============|=============
1 | 0
|
Codes: * - cam usage is above 90%.
Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM)
| IN-L2 ACL
| OUT-L2 ACL
| Total CAM | Used CAM
| 1536 |
| 206 |
|Available CAM
0 | 1536
9 | 197
127