Dell S4820T Configuration Manual page 43

CLI Command Mode
LLDP
LLDP MANAGEMENT INTERFACE Dell(conf-lldp-mgmtIf)#
LINE
MONITOR SESSION
OPENFLOW INSTANCE
PORT-CHANNEL FAILOVER-
GROUP
PRIORITY GROUP
PROTOCOL GVRP
QOS POLICY
VLT DOMAIN
VRRP
u-Boot
UPLINK STATE GROUP
The following example shows how to change the command mode from CONFIGURATION mode to
PROTOCOL SPANNING TREE.
Example of Changing Command Modes
Dell(conf)#protocol spanning-tree 0
Dell(config-span)#
Configuration Fundamentals
Prompt
Dell(conf-lldp)# or
Dell(conf-if—interface-
lldp)#
Dell(config-line-console)
or Dell(config-line-vty)
Dell(conf-mon-sess-
sessionID)#
Dell(conf-of-instance-of-
id)#
Dell(conf-po-failover-
grp)#
Dell(conf-pg)#
Dell(config-gvrp)#
Dell(conf-qos-policy-out-
ets)#
Dell(conf-vlt-domain)#
Dell(conf-if-interface-
type-slot/port-vrid-vrrp-
group-id)#
Dell=>
Dell(conf-uplink-state-
group-groupID)#
Access Command
protocol lldp
(CONFIGURATION or INTERFACE
Modes)
management-interface (LLDP
Mode)
line console orline vty
monitor session
openflow of-instance
port-channel failover-
group
priority-group
protocol gvrp
qos-policy-output
vlt domain
vrrp-group
Press any key when the following
line appears on the console
during a system boot: Hit any
key to stop autoboot:
uplink-state-group
43