To Edit Waveform - Rigol MSO1000Z series User Manual

RIGOL
8. Delete
Press Delete to delete the current point from the waveform and connect the
remaining points using the current interpolation mode.
Note:
Point 1 cannot be deleted.
9. APPly
Press Apply to finish editing the current waveform and output the edited
waveform.
10. Save
Press Save to enter the file store interface. Please refer to the introduction in
"Store and Recall" to save the current waveform file in ".arb" format in the
internal memory or external memory (you can overwrite the original file or save
the current waveform again). You can select the arbitrary waveforms in the
internal or external memory for output. For the details, refer to the introduction
in "To Select Waveform".

To Edit Waveform

Users can edit the waveform stored. Press Edit to enter the waveform editing menu.
1. Interp
Press Interp to turn on or off the interpolation mode between the points of the
waveform.
ON: the waveform editor connects two points using a straight line.

OFF: the waveform editor will keep a constant voltage level between the

two points and create a ladder-like waveform when the interpolation is
disabled.
2. Zoom
Press Zoom to turn on or off the zoom function.
ON: the waveform editing window only displays the current point.

OFF: the waveform editing window displays all the initial points.

3. Current Point
Press CurPoint to set the point to be edited. The range is from 1 to the initial
points. For the setting method, please refer to the introduction in "Parameter
Setting Method".
4. Voltage
Press Voltage to set the voltage of the current point. The range is from -2.5 V to
+2.5 V and the default is 0.000 mV. For the setting method, please refer to the
introduction in "Parameter Setting Method".
13-14
Chapter 13 Signal Source
MSO1000Z/DS1000Z User's Guide