Rigol MSO1000Z series User Manual page 247

Chapter 16Remote Control
select the GPIB address set in the oscilloscope from the comboBox of
"0::INSTR".
Click "Test" to check whether the GPIB communication works normally; if

not, please follow the corresponding prompt messages to solve the
problem.
5. View device resource
Click "OK" to return back to the main interface of Ultra Sigma. The GPIB
instrument resources found will appear under the "RIGOL Online Resource"
directory.
6. Communication Test
Right-click the resource name "MSO1104Z (GPIB0::1::INSTR)" to select "SCPI
Panel Control" to turn on the remote command control panel through which you
can send commands and read data as shown in the figure below.
MSO1000Z/DS1000Z User's Guide
RIGOL
16-9