Rigol MSO1000Z series User Manual page 255

Chapter 18 Specifications
Data Bits
I2C Trigger (Option)
Trigger
Condition
Address Bits
Address Range
Byte Length
SPI Trigger (Option)
Trigger
Condition
Timeout Value
Data Bits
Data Line
Setting
Measure
Cursor
Auto
Measurement
Number of
Measurements
Measurement
Range
Measurement
Statistic
Frequency
Counter
MSO1000Z/DS1000Z User's Guide
5 bit, 6 bit, 7 bit, 8 bit
Start, Restart, Stop, Missing ACK, Address, Data, A&D
7 bits, 8 bits, 10 bits
0x0 to 0x7F, 0x0 to 0xFF, 0x0 to 1023
1 to 5
Timeout, CS
16 ns to 10 s
4 bit to 32 bit
H, L, X
Manual Mode
Track Mode
Auto Mode
Analog channel:
Period, Frequency, Rise Time, Fall Time, Positive Pulse Width,
Negative Pulse Width, Positive Duty Cycle, Negative Duty Cycle,
tVmax, tVmin, Positive Rate, Negative Rate, Delay 12 , Delay
12 , Phase 12 , Phase 12 , Maximum, Minimum,
Peak-Peak Value, Top Value, Bottom Value, Amplitude, Upper
Value, Middle Value, Lower Value, Average, Mean Square Root,
Overshoot, Pre-shoot, Area, Period Area, Variance
Digital channel:
Frequency, Period, Positive Pulse Width, Negative Pulse Width,
Positive Duty Cycle, Negative Duty Cycle, Delay 12 , Delay
12 , Phase 12 , Phase 12
Display 5 measurements at the same time.
Screen or cursor
Average, Max, Min, Standard Deviation, Number of
Measurements
Hardware 6 bit frequency counter
(channels are selectable)
Voltage Deviation between Cursors (△V)
Reciprocal of △T (Hz) (1/△T)
Time Deviation between Cursors (△T)
Voltage and Time Values of the Waveform
Point
Allow to display cursors during auto
measurement
RIGOL
18-5