Or" Operation - Rigol MSO1000Z series User Manual

RIGOL
"Fx Operation").
Note: Smooth is grayed out and disabled. It is only available for differential
operation.
You can also use HORIZONTAL

SCALE to adjust the horizontal position and scale of the operation results.

"OR" Operation

Perform logic "OR" operation on the waveform voltage values of the specified
sources point by point and display the results. In operation, when the voltage value
of the source channel is greater than the threshold of the corresponding channel, it is
regarded as logic "1"; otherwise logic "0".
The results of logic OR operation of two binary bits are as follows.
Table 6-3 Logic "OR" Operation
A B
0 0
0 1
1 0
1 1
Press MATH  Math  Operator to select "A||B":
Press Operation to enable or disable the "OR" operation function.

Press SourceA and SourceB to select the desired channels (CH1-CH4 or

D0-D15).
― If source A selects any channel in CH1-CH4, press Thre.A and use
the threshold of source A in logic operation. If source A selects any channel
in D0-D15, Thre.A will be hidden automatically.
― If source B selects any channel in CH1-CH4, press Thre.B and use
the threshold of source B in logic operation. If source B selects any channel
in D0-D15, Thre.B will be hidden automatically.
Press Offset and use

Press Scale and use

Press Scale Reset to adjust the vertical scale of the operation results to the

optimal value according to the current configuration.
Press Options to set the start and end points of the operation results, enable or

disable waveform invert, etc.
― Press Start and use
― Press End and use
― Press Invert to enable or disable the inverted display function of the
waveform.
― Press Sens. and use
from the analog signal on the source. The setting range is from 0.00 Div to
6-10
POSITION and HORIZONTAL
A||B
0
1
1
1
to adjust the vertical position of the operation results.
to adjust the vertical scale of the operation results.
to set the start point of the operation results.
to set the end point of the operation results.
to set the sensitivity of the digital signal converted
Chapter 6 MATH and Measurement
MSO1000Z/DS1000Z User's Guide
set
set