Extended Averaging Processing Specification (Un\G134) - Mitsubishi q64rd User Manual

3 SPECIFICATIONS

3.4.21 Extended averaging processing specification (Un\G134)

3 - 35
(1) When selecting sampling processing, averaging processing (time/count/moving
average) or primary delay filter, write the setting values to the buffer memory
address 134 (Un\134).
(2) Sampling processing is set to all channels as a default.
(3) When an out-of-range value is set, sampling processing is performed.
b15 b14 b13 b12 b11 b10
CH4
(4) The Operating Condition Setting Request (Y9) must be turn on/off to make this
setting valid.
POINT
(1) Use the Extended averaging processing specification (buffer memory address
134: (Un\G134)) to set the averaging processing. In this case, it is not required to
use Averaging processing specification (buffer memory address 9: Un\G9). (Any
value written to the area is ignored.)
(2) When replacing the Q64RD whose first 5 digits of product information are 07071
or earlier with the one of 07072 or later, there is compatibility within the setting
range of the Averaging processing specification (buffer memory address 9:
(Un\G9). Existing programs can be utilized without change.
However, when setting the moving average or primary delay filter, make setting in
the Extended averaging processing specification area (buffer memory address
134: Un\G134).
(3) The relation between Averaging processing specification (buffer memory address
9: Un\G9) and Extended averaging processing specification (buffer memory
address 134: Un\G134) is as follows:
• When 1H to 4H (other than 0) is written into Extended averaging processing
specification, the value of this area becomes valid.
(The setting of Extended averaging processing specification acts on Averaging
processing specification.)
• It becomes valid at the ON/OFF timing of the Operating Condition Setting
Request (Yn9).
(4) Refer to Section 3.4.5 for Averaging processing specification (buffer memory
address 9: Un\G9).
(5) When setting the Q64RD-G with the utility package, the initial setting using the
averaging processing specification does not exist. Make the initial setting using
Extended averaging processing specification.
b9 b8 b7 b6
CH3 CH2
MELSEC-Q
b5 b4 b3 b2 b1
CH1
b3 b2 b1
Set Values
Processing
Set Value
Sampling processing
Time averaging
Count averaging
Moving average
Primary delay filter
b0
b0
0
1
2
3
4
3 - 35