Utility Package (Gx Configurator-Ti); Utility Package Functions; Section - Mitsubishi q64rd User Manual

5 UTILITY PACKAGE (GX Configurator-TI)

5 UTILITY PACKAGE (GX Configurator-TI)

5.1 Utility Package Functions

Table 5.1 Utility Package (GX Configurator-TI) Function List
Function
(1) Make the initial setting for the following items on each channel.
• Conversion Enable/Disable Setting
• Sampling/Averaging Processing Selection (Q64RD)
• Extended Averaging Processing Selection
• Time/Count Averaging Selection (Q64RD)
• Time/Count/Moving Average/Time Constant Setting
Initial
• Warning Output Enable/Disable Setting
1
setting
• Setting Range (Q64RD)
• Setting Range 1 (Q64RD-G)
• Warning Output Lower Lower Limit Value
• Warning Output Lower Upper Limit Value
(2) The data set in the initial setting are stored as parameters in the programmable controller CPU, and
automatically written into the Q64RD/Q64RD-G when the programmable controller CPU is changed into
5
the RUN status.
(1) Make the refresh setting for the following items on each channel.
• Conversion Completion Flag
• CH Measured Temperature Value (16bit)
Auto
• Error Code
1
refresh
• Setting Range (Q64RD)
• Setting Range 1 (Q64RD-G)
(2) The data in the Q64RD/Q64RD-G buffer memory set in the auto refresh setting are read or written to set
devices automatically when the END instruction of the programmable controller CPU is executed.
Monitors and tests the buffer memory and I/O signals for the Q64RD/Q64RD-G.
• Module Ready
• Operating Condition Setting Completion Signal
• Operating Condition Setting Request
• Offset/gain Setting Mode Status Flag
• Disconnection Detection Signal
• Warning Output Signal
(1) CH Monitor/Test
• Conversion Enable/Disable Setting
• Sampling/Averaging Processing Selection (Q64RD)
• Extended Averaging Processing Selection
Monitor/test
• Time/Count Averaging Selection (Q64RD)
• Time/Count/Moving Average/Time Constant Setting
• Conversion Completion Flag
• Measured Temperature Value (16bit)
• Measured Temperature Value (32bit)
• Error Code
• Setting Range (Q64RD)
• Setting Range - Wire Connection (Q64RD)
• Setting Range 1 (Q64RD-G)
• Setting Range 2 - Wire Connection (Q64RD-G)
• Warning Output Enable/Disable Setting
• Warning Output Flag Lower Limit Value
5 - 1
Table 5.1 shows a list of the utility package functions.
Description
• Warning Output Upper Lower Limit Value
• Warning Output Upper Upper Limit Value
• Scaling Range Lower Limit Value
• Scaling Range Upper Limit Value
2
• Scaling Width Lower Limit Value
• Scaling Width Upper Limit Value
• Conversion setting for disconnection detection
• Conversion setting value for disconnection
detection
• Setting Range 2 (Q64RD-G)
• Warning Output Flag
• Disconnection Detection Flag
• CH Scaling Value
• CH Measured Temperature Value (32bit)
• Conversion Completion Flag
• Error Flag
• Error Clear Request
• Averaging Processing Selecion
• Extended Averaging Processing Selection
• Warning Output Flag Upper Limit Value
• Warning Output Lower Lower Limit Value
• Warning Output Lower Upper Limit Value
• Warning Output Upper Lower Limit Value
• Warning Output Upper Upper Limit Value
• Disconnection Detection Flag
• Scaling Value
• Scaling Range Lower Limit Value
• Scaling Range Upper Limit Value
• Scaling Width Lower Limit Value
• Scaling Width Upper Limit Value
• Conversion setting for disconnection
3
detection
• Conversion setting value for disconnection
3
detection
MELSEC-Q
Reference

section

Section 5.4
Section 5.5
Section 5.6
5 - 1