Mitsubishi q64rd User Manual page 15

1 OVERVIEW
1 - 3
(9) Error compensation by offset/gain value setting
Error compensation can be made by setting offset and gain values on each
channel.
As the offset and gain values, you can make selection from user settings and
factory settings.
(10) Warning output
If the temperature detected is outside the preset measurement range, an warning
can be output on each channel.
(11) Online Module Change
The module can be changed without the system being stopped.
Also, by using the dedicated instructions (G(P).OGLOAD, G(P). OGSTOR) or
writing to the buffer and turning on the corresponding Y signal, the offset/gain
values can be re-set to the Q64RD/Q64RD-G replaced online and they can be
transferred to the other Q64RD/Q64RD-G mounted in another slot. (Between the
same models only)
(12) Easy setting by utility package
The utility package, GX Configurator-TI is available separately.
This utility package is not necessarily to be used. However, using this makes the
initial setting and auto refresh setting easy on screen, reduces sequence
programs and enables easy setting and operation check.
MELSEC-Q
1 - 3