Mitsubishi q64rd User Manual page 93

5 UTILITY PACKAGE (GX Configurator-TI)
5 - 18
[Explanation of items]
(1) Items
Setting item
Current value
Setting value
(2) Command buttons
Current value display
Make text file
Start monitor /
Stop monitor
Execute test
Close
REMARK
The following describes an example where sampling processing for the selection
test operation is changed to a 10-time averaging processing setting when the
Q64RD id used.
(1) Set averaging processing in the setting value field for Sampling/Averaging
processing selection.
(2) Set number of times in the setting value field for Time/count selection.
(3) Click the setting value field for Time/count/move average/time constant setting
to select.
(4) After entering the count, press the Enter key.
At this point, nothing has been written to the Q64RD.
(5) Select the setting value fields that were specified in steps 1 to 4 while holding
down the Ctrl key.
(6) Click Execute test to execute write operation.
Once writing has been completed, the value that was written will be displayed in
the present value field.
: Displays I/O signals and buffer memory names.
: Monitors the I/O signal states and present buffer memory
values.
: Enter or select the data to be written into the buffer memory
for test operation.
Displays the current value of the item selected. (This is
used to check the text that cannot be displayed in the
current value field. However, in this utility package, all
items can be displayed in the display fields).
Creates a file containing the screen data in text file
format.
Selects whether or not to monitor current values.
Performs a test on the selected items. To select more
than one item, select them while holding down the
Ctrl key.
Closes the currently open screen and returns to the
previous screen.
MELSEC-Q
5 - 18