Mitsubishi q64rd User Manual page 87

5 UTILITY PACKAGE (GX Configurator-TI)
5 - 12
(3) Menu bar
(a) File menu
Intelligent function module parameters of the project opened by GX
Developer are handled.
[Open
parameters]
[Close
parameters]
[Save
parameters]
[Delete
parameters]
[Exit]
(b) Online menu
[Monitor/ Test]
[Read from PLC] : Reads intelligent function module parameters from the
[Write to PLC]
POINT
(1) Saving intelligent function module parameters in a file
Since intelligent function module parameters cannot be saved in a file by the
project saving operation of GX Developer, save them on the shown module
selection screen for intelligent function module parameter setting.
(2) Reading/writing intelligent function module parameters from/to a
programmable controller CPU using GX Developer
(a) Intelligent function module parameters can be read from and written into
the programmable controller CPU after having been saved in a file.
(b) Set the target programmable controller CPU in GX Developer: [Online]
[Transfer setup].
(c) When the Q64RD/Q64RD-G is installed to the remote I/O station, use
"Read from PLC" and "Write to PLC".
(3) Checking the required utility
While the start I/O is displayed on the Intelligent function module utility setting
screen, " " may be displayed for the model name.
This means that the required utility has not been installed or the utility cannot
be started from GX Developer.
Check the required utility, selecting [Tools] - [Intelligent function utility] - [Utility
list...] in GX Developer.
: Reads a parameter file.
: Closes the parameter file. If any data are modified, a
dialog asking for file saving will appear.
: Saves the parameter file.
: Deletes the parameter file.
: Closes this screen.
: Activates the Select monitor/test module screen.
CPU module.
: Writes intelligent function module parameters to the
CPU module.
MELSEC-Q
5 - 12