Ricoh D129 Service Manual page 607

012 LCT: Plain
013 LCT: Thick1
014 LCT: Thick2
By-pass Paper Size Detection
1007*
Controls paper size detection for the by-pass feed table.
001 Detection Timing
002 LG Detection
Fusing Idling
Switches fusing idling on/off. When on, printing will not start until enough
time has elapsed so the hot roller can reach optimum temperature. This
1103*
ensures even heat on the hot roller.
Switch on if fusing on the 1st and 2nd copies is incomplete (this may occur if
the room is cold.). You must switch SP1103-1 ON before you set the fusing
interval with SP1103-2.
001 Enable Fusing Idling
002 Interval
003 Idling Time at Every Job
SM Appendix
[-9 to 5 / -4 / 1 mm step]
[-15 to 15 / 0 / 5 mm step]
[0 to 1 / 0 / 1]
0: LT SEF, 1: LG
0 = Off, 1 = On
[0 to 60 / 30 / 1 sec.]
Sets the machine to fusing idling only for 30
sec. for every job (when the original is set on
the ARDF, when the ARDF cover is opened,
etc.) and the fusing unit has reached the
reload temperature (optimum temperature for
operation).
[0 to 30 / 0 / 1 sec.]
0: No idling done before a job.
3-3
System SP Table-1
D129/D130