Scanner
8.
Front scanner wire clamp [A]
9.
Front scanner wire bracket [B] (
10. Front scanner wire and scanner drive pulley [C] (
Reassembling the Front Scanner Wire
1.
Position the center ball [A] in the middle of the forked holder.
2.
Pass the right end (with the ball) [B] through the square hole. Pass the left end (with the
ring) [C] through the notch.
3.
Wind the right end counterclockwise (shown from the machine's front) five times. Wind the
left end clockwise twice.
The two red marks [D] come together when you have done this. Stick the wire to
the pulley with tape. This lets you easily handle the assembly at the time of
installation.
D129/D130
x 1)
x 1)
4-26
SM