Service Program Mode Tables; Service Table Key - Ricoh D129 Service Manual

Service Program Mode
3. After machine servicing is completed:

Change SP5169 from "1" to "0".

Turn the machine off and on.

Tell the administrator that you completed servicing the machine.

The administrator will then set the "Service Mode Lock" to ON.

5.1.2 SERVICE PROGRAM MODE TABLES

Please note these general changes in this section:

Group 8(Data Log 2) is a new group of counters.

Along with the addition of Group 8, many of the Group 7 counters have been removed.

Service Table Key

Notation
[range / default / step]
*
DFU
Japan only
C2b
C2c
SSP
D129/D130
Example: [-9 to +9 / 0 / 0.1 mm step]. The setting can be
adjusted in the range ±9, value reset to +3.0 after an NVRAM
reset, and the value can be changed in 0.1 mm steps with
each key press.
Value stored in NVRAM. After a RAM reset, this default value
(factory setting) is restored.
Denotes "Design or Factory Use". Do not change this value.
The feature or item is for Japan only. Do not change this
value.
D129
D130
This denotes a "Special Service Program" mode.
5-2
What it means
SM