Low/Reverse Clutch Housing Snap Ring Identification; Completed Low/Reverse Clutch Housing - ATSG Chrysler 45RFE Service Manual

Snap Ring No. 1
Snap Ring No. 2
Snap Ring No. 3
Snap Ring No. 4
Snap Ring No. 5
Snap Ring No. 6
16. Install the low roller clutch assembly into the
low/reverse clutch housing by rotating outer
race clockwise to engage each of the friction
plates until it is fully seated.
17. The low/reverse clutch housing has one wider
spline on the inner hub where the inner race
splines to it, and the inner race must be turned
to engage the splines (See Figure 57). This is
done to ensure alignment of the lube holes.
18. After the low roller clutch assembly is fully
seated, install the "upper" overrun clutch snap
ring into the groove (See Figure 57).
19. Set the completed low/reverse clutch housing
aside for final assembly (See Figure 59).
AKPPHELP.RU Руководство по ремонту АКПП
Technical Service Information

LOW/REVERSE CLUTCH HOUSING SNAP RING IDENTIFICATION

Thickness I.D. to O.D.
"Split" Ring
Flat .061"
Flat .061"
Flat .038"
Flat .080"
Tapered .080"
Case
AUTOMATIC TRANSMISSION SERVICE GROUP
Notes:
.154"
.154" Same as Ring No. 2.
.187"
.186"
.188" Retains the housing in case.
Low/Reverse
Clutch Housing
Figure 58

COMPLETED LOW/REVERSE CLUTCH HOUSING

Snap Ring No. 6
Snap Ring No. 5
Snap Ring No. 4
Snap Ring No. 3
Snap Ring No. 2
Snap Ring No. 1
(Split Ring)
Copyright © 1999 ATSG
Copyright © 1999 ATSG
Figure 59
47