ATSG Chrysler 45RFE Service Manual page 86

FINAL TRANSMISSION ASSEMBLY (Cont'd)
23. Install the number 9 thrust bearing onto to back
side of the reaction carrier/reverse sun gear
assembly, in the direction shown in Figure 115,
and retain with a small amount of TransJel®.
24. Install the reaction carrier/reverse sun gear
assembly, with bearing, into the transmission
by rotating into position (See Figure 115).
25. Install the number 8 thrust bearing down inside
of reaction carrier/reverse sun gear assembly in
the direction shown in Figure 116.
26. Install the reaction sun gear in transmission by
rotating into position (See Figure 116).
27. Install the number 7 thrust bearing into back
side of the reaction internal gear, in direction
shown in Figure 116, and retain with a small
amount of TransJel®.
28. Install the reaction internal gear assembly into
trans by rotating into position (See Figure 116).
29. Install rear selective plate on reaction ring gear
with oil grooves facing down and engaged on
tabs as shown in Figure 116.
1
2
1. REACTION CARRIER/REVERSE SUN GEAR ASSEMBLY.
2. NUMBER 9 THRUST BEARING.
86
AKPPHELP.RU Руководство по ремонту АКПП
Technical Service Information
Figure 115
AUTOMATIC TRANSMISSION SERVICE GROUP
30. Install the 2nd clutch backing plate into case as
shown in Figure 117.
31. Install the 2nd clutch pack into case beginning
with a lined plate and alternating with steels
until you have installed 2 lined & 2 steel plates
as shown n Figure 117.
32. Install the 2-4 clutch retainer flat snap ring into
lower groove in the transmission case. Refer to
Figure 118.
1
2
3
4
5
1. REAR SELECTIVE THRUST PL ATE.
2. REACTION INTERNAL RING GEAR ASSEMBLY.
3. NUMBER 7 THRUST BEARING.
4. REACTION SUN GEAR.
Figure 116
Copyright © 1999 ATSG