Input Clutch Housing Assembly - ATSG Chrysler 45RFE Service Manual

5
1. INPUT CLUTCH HUB/ INPUT SHAFT ASSEMBLY.
2. DRAIN BACK BALL CAPSULE, WITH "O" RING ASSEMBLY .
3. BALL CAPSULE ASSEMBLY RETAINING SNAP RING.
4. CIR-CLIP TO RETAIN INPUT SHAFT.
5. REVERSE OUTER LIP SEAL (INSIDE LIP).
Figure 72
AKPPHELP.RU Руководство по ремонту АКПП
Technical Service Information
4799090
4
3
2
1
AUTOMATIC TRANSMISSION SERVICE GROUP

INPUT CLUTCH HOUSING ASSEMBLY

1. Disassemble the input clutch housing using the
illustrations in Figures 69 and 70 as a guide.
2. Clean and inspect all components. Replace any
parts that show evidence of wear or damage.
3. Remove the small "eyelet" snap ring from the
input shaft as shown in Figure 72.
4. Remove the drain back ball capsule assembly
from the input shaft using a pick tool. Remove
and discard the "O" ring (See Figure 72).
5. Install a new "O" ring on the ball capsule and
lubricate with small amount of TransJel®.
6. Install the drain back ball capsule back into the
input shaft in the direction shown in Figure 72.
7. Install the "eyelet" snap ring and ensure that it
is fully seated (See Figure 72).
8. Install new lip seal into the groove in the input
clutch hub with the lip facing down as shown
in Figure 72 and lubricate with a small amount
of TransJel®.
9. The "O" rings on the input clutch hub are color
coded. Install Green and Red colored "O" rings
in the positions shown in Figure 73, and lube
with a small amount of TransJel®.
Continued on Page 58.
RED COLORED
"O" RING
Figure 73
GREEN COLORED
"O" RING
Copyright © 1999 ATSG
57