ATSG Chrysler 45RFE Service Manual page 84

FINAL TRANSMISSION ASSEMBLY (Cont'd)
12. Install the low/reverse clutch housing into the
transmission case as shown in Figure 111. The
clutch housing has one lug that is wider than
all the rest to orient it in the case with the feed
hole toward the valve body.
13. Install the tapered snap ring into the groove in
the case just above the low/reverse housing and
ensure that it is fully seated (See Figure 111).
14. Install the number 12 thrust bearing assembly
onto the low/reverse clutch housing with the
inside tabs facing down (See Figure 112).
1
2
1. LOW/REVERSE CLUTCH HOUSING "TAPERED" SNAP RING.
2. LOW/REVERSE CLUTCH HOUSING ASSEMBLY.
84
AKPPHELP.RU Руководство по ремонту АКПП
Technical Service Information
Copyright © 1999 ATSG
Figure 111
AUTOMATIC TRANSMISSION SERVICE GROUP
15. Install the input internal ring gear assembly as
shown in Figure 112 and ensure that the lugs
are engaged onto the low roller outer race.
16. Air check the low/reverse clutch pack and also
verify low roller clutch for correct operation.
17. Install input carrier/reverse internal ring gear as
shown in Figure 113, by rotating into position,
to engage the teeth on input internal ring gear.
18. Install the number 11 thrust bearing assembly
into the input carrier in the direction shown in
Figure 113.
Continued on Page 85.
1
2
1. INPUT INTERNAL RING GEAR ASSEMBLY.
2. NUMBER 12 THRUST BEARING.
Figure 112
Copyright © 1999 ATSG