2-4 Clutch Retainer Assembly - ATSG Chrysler 45RFE Service Manual

6
5
4
2
1

1. 2-4 CLUTCH RETAINER ASSEMBLY.

2. 2ND CLUTCH PISTON OUTER SEAL.
3. 2ND CLUTCH PISTON INNER SEAL
4. 2ND CLUTCH PISTON.
5. 2ND CLUTCH PISTON BELLVILLE PLATE.
6. 2ND CLUTCH PISTON BELLVILLE PLATE SNAP RING.
50
AKPPHELP.RU Руководство по ремонту АКПП
Technical Service Information
3
Figure 62
AUTOMATIC TRANSMISSION SERVICE GROUP
2-4 CLUTCH RETAINER ASSEMBLY
1. Disassemble the 2-4 clutch retainer using the
illustrations in Figures 60 and 61.
2. Clean and inspect all components and replace
those components that show wear or damage.
3. Install new inner and outer seals on 2nd clutch
piston, as shown in Figure 62, and lubricate
with small amount of TransJel®.
4. Install the 2nd clutch piston in the 2-4 retainer
as shown in Figure 62.
5. Install the 2nd clutch piston bellville plate on
top of the 2nd clutch piston in retainer.
6. Position the 2nd clutch bellville plate snap ring
on top of the bellville plate (See Figure 63).
7. Using a suitable shop press, compress bellville
spring until the snap ring is engaged into the
snap ring groove in the 2-4 retainer, and ensure
that it is fully seated as shown in Figure 63.
8. Install new inner and outer seals on 4th clutch
piston, as shown in Figure 65, and lubricate
with small amount of TransJel®.
9. Install the 4th clutch piston in the 2-4 retainer
as shown in Figure 65.
10. Install the 4th clutch piston return spring on top
of the piston as shown in Figure 65.
11. Position the return spring retaining snap ring on
top of the return spring (See Figure 65).
BELLVILLE
PLATE
Figure 63
BELLVILLE PLATE
SNAP RING
Copyright © 1999 ATSG