ATSG Chrysler 45RFE Service Manual page 58

4
3
2
1
1. OVERDRIVE/REVERSE PISTON BELLVILLE PLATE SNAP RING.
2. OVERDRIVE/REVERSE PISTON BELLVILLE PLATE.
3. OVERDRIVE/REVERSE PISTON ASSEMBLY.
4. OVERDRIVE OUTER LIP SEAL (INSIDE LIP).
5. OVERDRIVE/REVERSE INNER "O" RING SEAL.
58
AKPPHELP.RU Руководство по ремонту АКПП
Technical Service Information
4799090
5
Copyright © 1999 ATSG
Figure 74
AUTOMATIC TRANSMISSION SERVICE GROUP
INPUT CLUTCH HOUSING ASSEMBLY (Cont'd)
10. Install the overdrive/reverse bellville plate and
the retaining snap ring as shown in Figure 74,
if they were removed.
11. Install the overdrive outer lip seal into groove
inside the overdrive/reverse piston, with the lip
facing down, as shown in Figure 74.
12. Install the overdrive/reverse inner "O" ring seal
into the groove in the overdrive/reverse piston
as shown in Figure 74.
13. Lubricate both seals with small amount of
TransJel®.
14. Install the input clutch retainer into overdrive/
reverse piston by rotating into position, as
shown in Figure 75.
15. Install input clutch retainer and OD/Reverse
piston assembly onto the input clutch hub, as
shown in Figure 76.
16. Install the input clutch retainer tapered snap
ring, with the tapered side facing up, into the
groove in the input clutch hub as shown in
Figure 76.
Special Note: We have provided you with a
snap ring identification chart to identify the
snap rings, and identify their locations, in
Figure 71 on Page 56. This chart will identify
all snap rings in the input housing.
OVERDRIVE/REVERSE
PISTON ASSEMBLY
Figure 75
INPUT CLUTCH
RETAINER
Copyright © 1999 ATSG