ATSG Chrysler 45RFE Service Manual page 40

47. Remove the input internal ring gear assembly
from the transmission case (See Figure 44).
48. Remove the number 12 thrust bearing from the
low/reverse clutch housing assembly as shown
in Figure 44.
49. Remove the "Tapered" snap ring from the case
that retains the low/reverse clutch housing in
transmission case (See Figure 45).
50. Remove low/reverse clutch housing assembly
from the transmission case by lifting straight
up, as shown in Figure 45, and set aside for
component disassembly.
1
2
1. INPUT INTERNAL RING GEAR ASSEMBLY.
2. NUMBER 12 THRUST BEARING.
40
AKPPHELP.RU Руководство по ремонту АКПП
Technical Service Information
Copyright © 1999 ATSG
Figure 44
AUTOMATIC TRANSMISSION SERVICE GROUP
51. Remove the park rod retaining "E" clip from
the manual lever as shown in Figures 46 & 47.
52. Remove the park rod from the transmission as
shown in Figures 46 and 47.
53. Remove the manual shaft and lever assembly
retaining pin bolt using a 30 Torx bit as shown
in Figures 46 and 47.
54. Remove the manual shaft and lever assembly
through the inside of the case. Refer to Figures
46 and 47.
55. Remove and discard the manual shaft seal as
shown in Figure 47.
1
2
1. LOW/REVERSE CLUTCH HOUSING "TAPERED" SNAP RING.
2. LOW/REVERSE CLUTCH HOUSING ASSEMBLY.
Figure 45
Copyright © 1999 ATSG