Pump Cover Retainer Locations And Demensions - ATSG Chrysler 45RFE Service Manual

TCC ACCUM VALVE RETAINER
.530" WIDE AND .62" THICK
LIMIT VALVE RETAINER
.588" WIDE AND .62" THICK
REGULATOR VALVE RETAINER
.666" WIDE AND .62" THICK
SHUTTLE
VALVE
DOWEL
68
AKPPHELP.RU Руководство по ремонту АКПП
Technical Service Information

PUMP COVER RETAINER LOCATIONS AND DEMENSIONS

Figure 91
AUTOMATIC TRANSMISSION SERVICE GROUP
Figure 90
OIL PUMP AND COVER ASSEMBLY (Cont'd)
11. Ensure that the shuttle valve is installed into the
proper cavity in the oil pump body, and that the
dowels are installed as shown in Figure 91.
12. Install the oil pump spacer plate onto the pump
body over the dowels as shown in Figure 92.
DOWEL
13. Install the two screws to retain the spacer plate
on the pump and torque to 4.5 Nm (40 in lbs).
Refer to Figure 92.
14. Install the pre-assembled oil pump cover onto
the locating dowels as shown in Figure 93.
15. Seat the two oil pump halves together and very
carefully turn the assembly over as shown in
Figure 94. Start all 24 screws finger tight.
16. Torque all bolts slowly, starting in center and
working out in a circle, to 4.5 Nm (40 in lbs).
Refer to Figure 94.
17. Verify that the oil pump gears rotate freely.
SWITCH VALVE RETAINER
.588" WIDE AND .62" THICK
Copyright © 1999 ATSG
Continued on Page 70.