ATSG Chrysler 45RFE Service Manual page 44

ROLLER CLUTCH
"LOWER" SNAP RING
LOW/REVERSE
"SPLIT" RING
LOW/REVERSE
BELLVILLE PLATE
LOW/REVERSE
INNER SEAL
LOW/REVERSE
PISTON
LOW/REVERSE
OUTER SEAL
LOW/REVERSE
HOUSING
44
AKPPHELP.RU Руководство по ремонту АКПП
Technical Service Information
Copyright © 1999 ATSG
Figure 51
AUTOMATIC TRANSMISSION SERVICE GROUP
LOW/REVERSE CLUTCH HOUSING ASSEMBLY (Cont'd)
1. Clean and inspect all low/reverse clutch parts.
Replace any components that show evidence
of wear or damage.
2. Check the bleed orifice in the bottom of the
low/reverse clutch housing to ensure that it is
not plugged or restricted (See Figure 52).
3. Install new inner and outer seals onto the low
reverse piston and lubricate with small amount
of TransJel® (See Figure 51).
4. Install the low/reverse piston assembly into the
low/reverse clutch housing (See Figure 51).
5. Install the bellville plate on top of the piston as
shown in Figure 51.
6. Compress the low/reverse piston bellville plate
and install the split retaining ring to hold the
bellville spring in the clutch housing. Refer to
Figures 51 and 53.
7. Install the "lower" overrunning clutch snap ring
into the groove directly above the split ring in
the low/reverse clutch housing.
8. Install the inner race into the outer race. While
holding the inner race, rotate the outer race in
a clockwise direction to install (See Figure 55).
9. Install the spacer washer on top of the outer
race as shown in Figure 55.
10. Install the low roller clutch inner race retaining
snap ring into the groove above the spacer as
shown in Figure 54 and 55.
BLEED ORIFICE
Figure 52
Copyright © 1999 ATSG