Completed 2-4 Clutch Retainer Assembly - ATSG Chrysler 45RFE Service Manual

5
4
2
1
1. 2-4 CLUTCH RETAINER ASSEMBLY.
2. 4TH CLUTCH STEEL PLATES .098" THICK (3 REQUIRED).
3. 4TH CLUTCH FRICTION PLATES .090" THICK (3 REQUIRED).
4. 4TH CLUTCH BACKING PLATE .196" THICK.
52
AKPPHELP.RU Руководство по ремонту АКПП
Technical Service Information
Copyright © 1999 ATSG
Figure 66
AUTOMATIC TRANSMISSION SERVICE GROUP
2-4 CLUTCH RETAINER ASSEMBLY (Cont'd)
14. Install the 4th clutch pack beginning with a
steel plate and alternating with friction plate
until you have installed three of each plate, as
shown in Figure 66.
15. Install the 4th clutch backing plate, as shown in
Figure 66. This plate is non-directional and will
go in either way.
16. Install the 4th clutch backing plate selective
snap ring as shown in Figure 66, and ensure
that it is fully seated.
17. Measure the 4th clutch clearance. The correct
clutch clearance is 0.81-1.35 mm (.032"-.053").
18. Change the snap ring as necessary and verify
clutch clearance by re-measuring.
19. Set the completed 2-4 retainer assembly aside
for final assembly (See Figure 67.
3

COMPLETED 2-4 CLUTCH RETAINER ASSEMBLY

Copyright © 1999 ATSG
Figure 67