ATSG Chrysler 45RFE Service Manual page 35

14. Remove the six valve body retaining bolts that
are illustrated in Figure 33, using 8mm socket.
15. Remove the complete valve body and the
TRS/Solenoid body as an assembly as shown
in Figure 34, and set aside for component
disassembly.
16. Remove and discard the cooler oil filter from
the transmission case as shown in Figure 35.
17. Remove the cooler by-pass valve from case,
as shown in Figure 35.
18. Remove the outer snap ring retaining the trans-
mission front cover in the transmission case as
shown in Figure 36.
19. Remove the inner snap ring retaining the front
cover to the oil pump as shown in Figure 36.
20. Reach through one of the case openings in the
valve body area with a long blunted tool, and
tap the transmission front cover from the case.
Refer to Figure 36.
21. Remove the six bolts retaining the oil pump in
the transmission case (See Figure 36).
22. Remove the oil pump from the transmission.
Hold down on the input shaft to prevent the
input clutch housing assembly from coming
out with the oil pump (See Figure 36.
23. Set the oil pump assembly aside for component
disassembly.
Continued on next Page.
AKPPHELP.RU Руководство по ремонту АКПП
Technical Service Information
AUTOMATIC TRANSMISSION SERVICE GROUP
2
2
1. COMPLETE PUMP ASSEMBLY .
2. PUMP TO CASE RETAINING BOLTS (6 REQUIRED).
3. PUMP COVER PLATE (MOLDED SEALS).
4. PUMP COVER PLATE OUTER RETAINING SNAP RING.
5. PUMP COVER PLATE INNER RETAINING SNAP RING.
Figure 36
5
4
3
2
1
Copyright © 1999 ATSG
35