ATSG Chrysler 45RFE Service Manual page 90

FINAL TRANSMISSION ASSEMBLY (Cont'd)
46. Install the transmission front cover plate which
is stamped aluminum with molded inner and
outer seals as shown in Figure 123.
47. Install the outer front cover plate snap ring to
hold the front cover plate in the case as shown
in Figure 123.
48. Install the inner front cover plate snap ring onto
the oil pump assembly (See Figure 123).
2
1. PUMP COVER PLATE (MOLDED SEALS).
2. PUMP COVER PLATE OUTER RETAINING SNAP RING.
3. PUMP COVER PLATE INNER RETAINING SNAP RING.
90
AKPPHELP.RU Руководство по ремонту АКПП
Technical Service Information
Figure 123
AUTOMATIC TRANSMISSION SERVICE GROUP
49. Install the cooler filter by-pass valve into the
trans case and torque to 11.3 Nm (100 in lb).
Do Not over-torque! Refer to Figure 124.
50. Install cooler filter in transmission case using a
filter wrench (See Figure 124).
51. Air pressure test all clutch components again at
this time before valve body is installed using
Figure 125 as a guide.
Continued on Page 92.
3
1
Copyright © 1999 ATSG