Loading Tabbed Sheets In Multi-Sheet Bypass Tray - Konica Minolta bizhub pro c500 User Manual

Loading Tabbed Sheets in Multi-Sheet Bypass Tray

Front
Front
The tab extension width must be 12.5 mm or less.
1.
Open the Multi-sheet bypass tray located on the right side of
the copier.
2.
Load tabbed sheets as illustrated above.
3.
Adjust the paper guides to the paper size.
4.
Specify the paper type as TAB for the Multi-sheet bypass tray.
See p. 3-18 to p. 3-21 for specifying the paper type of the Multi-sheet bypass
tray.
2-32
Example: 3 Tabbed sheets loaded in position for one finished set.
Rear
Printed
side
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
Rear
Section 1
Introduction
Printed
side
Loading Paper (continued)
1st TAB
Section 1 2nd TAB
Introduction
3rd TAB
1st TABS
2nd TABS
Section 1
Introduction
3rd TABS
Section 1
Section 1
Introduction
Introduction
1st TAB
Section 1
2nd TAB
Introduction
3rd TAB
ONE FINISHED SET
1st TAB 2nd TAB
Section 1 Section 1
Introduction Introduction
3rd TAB
3 FINISHED SETS