Table of Contents
Advertisement
Repeating Automatically or Selecting RepeatingTimes (Repeat: AUTO/ Repeat Mode) (continued)
1.
Touch APPLICATION on the Basic Screen
When starting a new copying job, be sure to close the RADF securely, then
press [AUTO RESET].
2.
Touch Repeat on the Application Selection Screen.
The Repeat Mode Selection Screen will be displayed.
3.
Touch to highlight the desired mode key.
Touch AUTO to select the Auto Detection mode.
Touch 2 Repeat, 4 Repeat, or 8 Repeat to select the desired Repeat mode.
4.
Touch OK.
The Application Selection Screen will be restored.
Non-Image Area Erase is automatically selected on the Application Selection
Screen when AUTO mode is selected.
When 2 Repeat mode is selected, Page space function of Image Shift can be
used to make the desired amount of blank space between the two images on
a page. See p. 10-45 to p. 10-47.
5.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
10-38
Advertisement
Table of Contents
Troubleshooting
