Loading Paper Into The Bypass Tray - Konica Minolta Bizhub C353P User Manual

Before using the machine
5
Close the LCT.
– If special paper is loaded, the paper type setting must be specified. For details, refer to
Settings Menu" on page
Reminder
Be careful not to touch the film.
Do not load so many sheets of paper that the top of the stack is higher than the , mark.
For details on the paper that can be loaded into the LCT, refer to
Note
If the machine has entered Low Power mode or Sleep mode, the LCT cannot be pulled out, even after
the tray release button is pressed. Be sure to first cancel Low Power mode or Sleep mode.
1.4.3

Loading paper into the bypass tray

Paper can be fed manually through the bypass tray if you wish to print onto paper that is not loaded into a
paper tray, or if you wish to print onto thick paper 4, postcards, envelopes, OHP transparencies or label
sheets.
!
Detail
For thick paper 4, only A3 w, A4 v, 11 × 17 w and 8-1/2 × 11 v are available for printing.
1
Open the bypass tray.
– When loading large-sized paper, pull out the tray
extension.
2
With the side to be printed on facing down, insert the paper as much as possible into the feed slot.
3
Slide the lateral guides to fit the size of paper being
loaded.
? How is curled paper loaded?
% Flatten the paper before loading it.
How many sheets of paper and other media can be
?
loaded?
% Do not load so many sheets of plain paper that the top
of the stack is higher than the , mark.
C353P
8-17.
"Paper
"Paper" on page 1-18.
Tray
extension
Lateral
guides
1
1-25