Sony SAL16105 Service Manual page 5

NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, dont' pull at wire of connector. It is possible that a wire is snapped.
• When installing a connector, dont' press down at wire of connector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
UNIVERSAL WRENCH
In case of the following notches or holes are located in the lens block, etc during disassembling/
assembling the lens, Use the universal wrench.
Notches
How to Use
Attach the chip-A or chip-B to the universal wrench.
For the notches: chip-A
For the holes: chip-B
Match the universal wrench to the holes or notches of the lens block, etc.
Match the universal wrench
to the width of holes or notches.
Chip
SERVICE TOOLS
A-20
Anti-diffusion agent (A-20):
B-10 Adhesive bond (B-10):
B-40
Adhesive bond (B-40):
B-110
Adhesive bond (B-110):
LOCTITE 460
or the equivalent
SAL16105 (DT 3.5-5.6/16-105) (DT 16-105mm F3.5-5.6)
Universal wrench
J-6082-609-A
Chip
J-6082-611-A
J-6082-612-A
J-6082-614-A
J-6082-617-A
Adhesive bond (LOCTITE 460)
or the equivalent.
2. DISASSEMBLY
Holes
Chip-A for
universal wrench:
J-6082-609-1
Chip-A
Universal wrench
O-20
Oil (O-20):
G-115
Grease (G-115):
G-116 Grease (G-116):
G-118
Grease (G-118):
2-1
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
Chip-B for
universal wrench:
J-6082-609-2
Notches
Chip-B
Holes
J-6082-610-A
J-6082-627-A
J-6082-628-A
J-6082-680-A
Chip-A
Chip-B