Download  Print this page

Advertisement

4-4-2. Projective Resolving Power Check

Note:
• Check the projective resolving power. If it does not meet the specification, adjust the projective resolving power, projective
resolving power (partial blur) adjustment meet the specifications respectively.
Projective Resolving Power (Partial Blur) Adjustment
Check the projective resolving power. Conform the following adjustment if necessary.
1)
Set the focal length of lens to 105 mm and adjust the focus so that the center "y'= 0" reaches the maximum resolution.
2)
Check projective resolving power at reach peripheral point of "y'= 12".
If the projective resolving power does not meet the specification, perform the following.
(1) Rotate the 4th lens block, adjust the defective parts to out of picture frame.
(2) If the adjustment is impossible according to the procedure (1), replace the 4th lens block.
(3) If the specification is not improved according to procedure (2), replace the 2nd lens barrel assy.
Note:
Do not change of thickness of the 3-4 interval adjustment washer.
SAL16105 (DT 3.5-5.6/16-105) (DT 16-105mm F3.5-5.6)
4-24

Advertisement

Table of Contents

   Also See for Sony SAL16105

   Related Manuals for Sony SAL16105

Comments to this Manuals

Symbols: 0
Latest comments: