Apply the adhesive bond (B-10) to the heads of screw and projection as shown in the figure.
Apply the adhesive
Confirm the focus adjustment point doesn't go out of order with setting it to near position or infinity position again.
3. In case of error display in the Search Focus Adjustment Point
When the error display and the NG display appear to the pop-up window, press the ENTER key to return to the initial window, and
push ENTER key.
Move the position of focus brush right and left, and perform "2. Adjusting Method" again.
SAL16105 (DT 3.5-5.6/16-105) (DT 16-105mm F3.5-5.6)