Sony SAL16105 Service Manual page 34

HELP04-07
1. Peel off the release paper (on the focus pattern side) of CL block, lay it and insert it into the square hole on outer barrel. (Fig. a)
2. Stand CL-002 block up. (Fig. b)
3. Put the tip of CL-002 block to the edge (Part A) on outer barrel and stick it. (Fig. c)
CL-002 Block
Hole of the
Outer Barrel
Fig.a
4. Peel off the release paper (on the zoom pattern side) of CL-002 block. (Fig. d)
5. Stick the CL-002 block while putting it to the standard B. (Fig. e/f)
Release Paper
Fig.d
6. Roll CL-002 block up tracing the guide line and stick it to be fitted to the corners C and D. (Fig. g/h)
7. Peel off the release paper (on the part E) of CL-002 block, stick it to be fitted to the shape of outer barrel. (Fig. i/j)
Note:
Be to stick it so that there is no floating point at the part F. (Fig. j)
Fig.g
8. Stick it fitting to the edge of outer barrel. (Fig. k)
Note:
Be sure not to bring it out to the arrow direction.
9. Wrinkle the flexible board while pulling slightly CL-002 block.
10. Wrinkle the part G of CL-002 block lightly. (Fig. m)
Fig.k
SAL16105 (DT 3.5-5.6/16-105) (DT 16-105mm F3.5-5.6)
CL-002 Block
CL-002 Block
Standard B
GL-002 Block
Corner C
Fig.h
Fig.b
Fig.e
Part E
Corner D
Fig.l
Part A
Fig.c
CL-002 Block
Fig.f
CL-002 Block
Part F
Fig.i Fig.j
Part G
Fig.m
HELP