Download  Print this page

Advertisement

Ver. 1.2 2008.02
The changed portions from
Ver. 1.1 are shown in blue.
2. In case of 2nd lens barrel assy replaced
Replace the 2nd lens barrel assy, flange back value of lens checked do not meet specification in middle range (focal length : 24 to 90 mm),
perform the following.
In case of positive (+) of flange back value, make the 2nd block adjustment washer thicker.
In case of negative (-) of flange back value, make the 2nd block adjustment washer thinner.
2ND BLOCK ADJUSTMENT WASHER
Part.No
3-292-495-01
Note:
2nd block adjustment washer that can be used for service is only thickness of 0.05 mm.
Except when you replace the 2nd lens barrel assy, the thickness do not be changed from shipping.
SAL16105 (DT 3.5-5.6/16-105) (DT 16-105mm F3.5-5.6)
t(mm)
0.05
1st Cam Ring
Decoration Plate
2nd Decoration Plate
2nd Lens Barrel Assy
2nd Block Adjustment Washer
Fig.4-6-3
4-30

Advertisement

Table of Contents

   Also See for Sony SAL16105

   Related Manuals for Sony SAL16105

Comments to this Manuals

Symbols: 0
Latest comments: